Pico 3000-sorozat USB oszcilloszkópok

  • 50-200MHz sávszélesség
  • 1GS/s mintavételezés
  • 2 vagy 4 analóg csatorna
  • 50-200MHz spektrumanalizátor
  • Beépített funkció vagy arbitrázs generátor
  • MSO típusoknál továbbá:
  • 16 digitális bemenet logikai analizátor funkcióval
  • 100MHz bemeneti frekvencia
  • 2 programozható küszöbérték

Leírás

  • PicoScope Model 3203D
    & MSO
    3204D
    & MSO
    3205D
    & MSO
    3206D
    & MSO
    3403D
    & MSO
    3404D
    & MSO
    3405D
    & MSO
    3406D
    & MSO
    Input channels 2 channels, BNC single-ended 4 channels, BNC single-ended
    Bandwidth
    (−3 dB)
    50 MHz 70 MHz 100 MHz 200 MHz 50 MHz 70 MHz 100 MHz 200 MHz
    Rise time (calculated) 7.0 ns 5.0 ns 3.5 ns 1.75 ns 7.0 ns 5.0 ns 3.5 ns 1.75 ns
    Hardware bandwidth limiter Switchable, 20 MHz
    Vertical resolution 8 bits
    Input ranges ±20 mV to ±20 V full scale in 10 ranges
    Input sensitivity 4 mV/div to 4 V/div in 10 vertical divisions
    Input coupling AC / DC, programmable
    Input characteristics 1 MΩ ±1%, in parallel with 14 pF ±1 pF
    DC accuracy ±3% of full scale ±200 μV
    Analog offset range
    (vertical position adjust)
    ±250 mV (20 mV, 50 mV, 100 mV, 200 mV ranges)
    ±2.5 V (500 mV, 1 V, 2 V ranges)
    ±20 V (5 V, 10 V, 20 V ranges)
    Offset adjust accuracy ±1% of offset setting, additional to DC accuracy
    Overvoltage protection ±100 V (DC + AC peak)
    Oscilloscope — vertical (digital inputs, MSOs only)
    Input channels 16 channels (2 ports of 8 channels each)
    Input connectors 2.54 mm pitch, 10 x 2 way connector
    Maximum input frequency 100 MHz (200 Mb/s)
    Minimum detectable pulse width 5 ns
    Channel-to-channel skew 2 ns, typical
    Minimum input slew rate 10 V/µs
    Input impedance 200 kΩ ±2% ∥ 8 pF ±2 pF
    Input dynamic range ±20 V
    Overvoltage protection ±50 V
    Digital threshold range ±5 V
    Threshold grouping Two independent threshold controls: D0…D7 and D8…D15
    Threshold selection TTL, CMOS, ECL, PECL, user-defined
    Threshold accuracy < ±350 mV (inclusive of hysteresis)
    Hysteresis < ±250 mV
    Minimum input voltage swing 500 mV pk-pk
    Oscilloscope — horizontal
    PicoScope Model 3203D
    & MSO
    3204D
    & MSO
    3205D
    & MSO
    3206D
    & MSO
    3403D
    & MSO
    3404D
    & MSO
    3405D
    & MSO
    3406D
    & MSO
    Maximum sampling rate (real-time) 1 GS/s (1 analog channel)
    500 MS/s (up to 2 analog channels or digital ports*)
    250 MS/s (up to 4 analog channels or digital ports*)
    125 MS/s (all other combinations)
    Maximum effective sampling rate (repetitive signals)** 2.5 GS/s 5 GS/s 10 GS/s 2.5 GS/s 5 GS/s 10 GS/s
    Maximum sampling rate
    (continuous streaming mode)
    17 MS/s in PicoScope software
    125 MS/s when using the supplied SDK (PC-dependent)
    Maximum capture rate 100,000 waveforms/second (PC-dependent)
    Timebase ranges 1 ns/div to 5000 s/div 500 ps/div to 5000 s/div 1 ns/div to 5000 s/div 500 ps/div to 5000 s/div
    Buffer memory 64 MS 128 MS 256 MS 512 MS 64 MS 128 MS 256 MS 512 MS
    Buffer memory (streaming) 100 MS in PicoScope software.
    Up to available PC memory when using supplied SDK.
    Maximum buffer segments 10 000 in PicoScope software
    130 000 using SDK 250 000 using SDK 500 000 using SDK 1 000 000 using SDK 130 000 using SDK 250 000 using SDK 500 000 using SDK 1 000 000 using SDK
    Timebase accuracy ±50 ppm ±2 ppm ±50 ppm ±2 ppm
    Timebase drift per year ±5 ppm ±1 ppm ±5 ppm ±1 ppm
    Sample jitter 3 ps RMS typical
    ADC sampling Simultaneous on all enabled channels

    * A digital port consists of 8 digital channels, D0–7 or D8–15
    ** ETS mode on channel A only

    Dynamic performance (typical)
    PicoScope Model 3203D & MSO 3204D & MSO 3205D & MSO 3206D & MSO 3403D & MSO 3404D & MSO 3405D & MSO 3406D & MSO
    Crosstalk Better than 400:1 up to full bandwidth (equal voltage ranges)
    Harmonic distortion < −50 dB at 100 kHz full scale input
    SFDR 52 dB typical at 100 kHz full scale input
    (except ±20 mV range: 44 dB)
    Noise 110 µV RMS 160 µV RMS 110 µV RMS 160 µV RMS
    (typical, on ±20 mV range)
    Bandwidth flatness +0.3 dB, −3 dB from DC to full bandwidth, typical
    Triggering – general
    Source Analog channels, EXT trigger (not MSOs), digital channels (MSOs only)
    Trigger modes None, auto, repeat, single, rapid (segmented memory)
    Maximum pre–trigger capture Up to 100% of capture size
    Maximum post–trigger delay Up to 4 billion samples (selectable in 1 sample steps)
    Trigger rearm time < 0.7 µs at 1 GS/s sampling rate
    Maximum trigger rate Up to 10,000 waveforms in a 6 ms burst at 1 GS/s sampling rate, typical
    Triggering – analog channels
    Advanced triggers Edge, window, pulse width, window pulse width, dropout, window dropout, interval, logic, runt pulse
    Trigger types (ETS mode) Rising edge, falling edge (Ch A only)
    Trigger sensitivity Digital triggering provides 1 LSB accuracy up to full bandwidth of scope
    Trigger sensitivity (ETS mode) 10 mV p-p typical (at full bandwidth)
    Triggering – EXT trigger input, not MSO models
    Connector type Front panel BNC
    Advanced triggers Edge, pulse width, dropout, interval, logic
    Input characteristics 1 MΩ || 14 pF
    Bandwidth 50 MHz 70 MHz 100 MHz 200 MHz 50 MHz 70 MHz 100 MHz 200 MHz
    Threshold range ±5 V
    Coupling DC
    Overvoltage protection ±100 V (DC + AC peak)
    Triggering – digital channels, MSO models only
    Source D0 to D15
    Trigger types Pattern, edge, combined pattern and edge, pulse width, dropout, interval, logic
    Function generator
    Standard output signals Sine, square, triangle, DC voltage, ramp, sinc, Gaussian, half-sine, white noise, PRBS
    Standard signal frequency DC to 1 MHz
    Sweep modes Up, down, dual with selectable start / stop frequencies and increments
    Triggering Free-run, or from 1 to 1 billion counted waveform cycles or frequency sweeps. Triggered from scope trigger or manually.
    Output frequency accuracy As oscilloscope
    Output frequency resolution < 0.01 Hz
    Output voltage range ±2 V
    Output voltage adjustment Signal amplitude and offset adjustable in approximate 1 mV steps within overall ±2 V range
    Amplitude flatness < 0.5 dB to 1 MHz typical
    DC accuracy ±1% of full scale
    SFDR > 60 dB 10 kHz full scale sine wave
    Output impedance 600 Ω
    Connector type Front panel BNC (non-MSO models)
    Rear panel BNC (MSO models)
    Overvoltage protection ±20 V
    Arbitrary waveform generator
    Update rate 20 MS/s
    Buffer size 32 kS
    Resolution 12 bits (output step size approximately 1 mV)
    Bandwidth > 1 MHz
    Rise time (10% to 90%) < 120 ns

    Other AWG specifications as function generator

    Probe compensation output
    Impedance 600 Ω
    Frequency 1 kHz
    Level 2 V pk-pk, typical
    Spectrum analyzer
    Frequency range DC to maximum bandwidth of scope
    Display modes Magnitude, peak hold, average
    X axis Linear or log 10
    Y axis Logarithmic (dbV, dBu, dBm, arbitrary) or linear (volts)
    Windowing functions Rectangular, Gaussian, triangular, Blackman, Blackman–Harris, Hamming, Hann, flat-top
    Number of FFT points Selectable from 128 to 1 million in powers of 2
    Math channels
    General functions −x, x+y, x−y, x*y, x/y, x^y, sqrt, exp, ln, log, abs, norm, sign, sin, cos, tan, arcsin, arccos, arctan, sinh, cosh, tanh, derivative, integral, delay
    Filter functions Low pass, high pass, band stop, band pass
    Graphing functions Frequency, duty cycle
    Multi-waveform functions Min, max, average, peak
    Operands All analog and digital input channels, reference waveforms, time, constants, pi
    Automatic measurements (analog channels only)
    Oscilloscope mode AC RMS, true RMS, cycle time, DC average, duty cycle, falling rate, fall time, frequency, high pulse width, low pulse width, maximum, minimum, peak to peak, rise time, rising rate
    Spectrum mode Frequency at peak, amplitude at peak, average amplitude at peak, total power, THD %, THD dB, THD+N, SFDR, SINAD, SNR, IMD
    Statistics Minimum, maximum, average, standard deviation
    Serial decoding
    Protocols 1-Wire, ARINC 429, CAN, DCC, DMX512, Ethernet (10BaseT, 100BaseTX), FlexRay, I²C, I²S, LIN, PS/2, SENT, SPI, UART/RS-232, USB 1.0
    Mask limit testing
    Statistics Pass/fail, failure count, total count
    Display
    Interpolation Linear or sin(x)/x
    Persistence modes Digital color, analog intensity, fast, custom
    Miscellaneous
    Output file formats BMP, CSV, GIF, JPEG, MATLAB 4, PDF, PNG, PSDATA, PSSETTINGS, TXT
    Output functions Copy to clipboard, print
    Software
    Windows software PicoScope for Windows
    PicoSDK Software development kit (SDK)
    Windows 7, 8 or 10 recommended (read more)
    macOS software PicoScope for macOS (beta: feature list)
    Software development kit (SDK)
    OS versions: see release notes
    Linux software PicoScope for Linux (beta: feature list)
    Software development kit (SDK)
    See Linux Software & Drivers for details of supported distributions
    Languages Chinese (simplified), Chinese (traditional), Czech, Danish, Dutch, English, Finnish, French, German, Greek, Hungarian, Italian, Japanese, Korean, Norwegian, Polish, Portuguese, Romanian, Russian, Spanish, Swedish, Turkish
    Physical specifications
    Dimensions 190 mm x 170 mm x 40 mm (including connectors)
    Weight < 0.5 kg
    Temperature range Operating: 0 °C to 40 °C (15 °C to 30 °C for stated accuracy).
    Storage: –20 °C to 60 °C
    Humidity range Operating: 5% RH to 80% RH non-condensing.
    Storage: 5% RH to 95% RH non-condensing
    Altitude range Up to 2000 m
    Pollution degree 2
    General
    Package contents PicoScope 3000D Series oscilloscope
    2 or 4 switchable 10:1/1:1 oscilloscope probes
    Quick Start Guide
    USB 3.0 cable
    AC power adaptor (4-channel models only)
    TA136 digital cable (MSOs only)
    2 × TA139 pack of 10 logic test clips (MSOs only)
    PC connectivity USB 3.0 SuperSpeed (USB 2.0 compatible)
    Power requirements Powered from a single USB 3.0 port or two USB 2.0 ports.
    4-channel models: AC adaptor included for use with USB ports that supply less than 1200 mA
    Safety approvals Designed to EN 61010-1:2010
    EMC approvals Tested to EN 61326-1:2006 and FCC Part 15 Subpart B
    Environmental approvals RoHS and WEEE compliant
    Warranty 5 years

Videó










Specifikáció

Letölthető termék információ: Pico 3000-sorozat

http://www.globalfocus.hu/ujglobalfocus/wp-content/uploads/2017/12/Picoscope_3000_-Sorozat_H.compressed.pdf

Ajánlatkérés

Célunk, hogy minél egyszerűbbé tegyük  az Ön számára az ajánlatkérést.

Kérjük, töltse ki az alábbi űrlapot és küldje el.

Kollégáink hamarosan jelentkezni fognak az ajánlattal.

Ajánlatkérés

Telefonos visszahívás kérése

Célunk, hogy minél egyszerűbbé tegyük  az Ön számára a termékeinkkel kapcsolatos információhoz jutást.

Kérjük, töltse ki az alábbi űrlapot és küldje el.

Kollégáink hamarosan jelentkezni fognak, hogy megválaszolják kérdését.

Telefonos visszahívás